When connected to a point,
this component has an effect only when
the value at that point is the floating value (Z).
In this case, the resistor pulls the wire to which it is connected
toward the value indicated in its
Pull Direction attribute.
If it is connected to a multiple-bit value, then each bit in the value that is floating is pulled in the direction specified, while the bits that are not floating are left unchanged.
The resistor has just one pin, which is an output and has a bit width that is derived from whichever component it is connected.
When the component is selected or being added,
the arrow keys alter its
Zurück zur Bibliotheksreferenz