Logisim 1.0 D/J-K Flip-Flop

Bibliothek:	Legacy
Eingeführt:	2.0 Beta 12
Aussehen:

Verhalten

These components exist only for backwards compatibility with Logisim 1.0X; for new circuits, the Memory library's flip-flops are recommended instead.

Each flip-flop stores a single bit of data, which is emitted through the Q output on the east side. Normally, the value can be controlled via the inputs to the west side. In particular, the value changes when the clock input, marked by a triangle on each flip-flop, rises from 0 to 1; on this rising edge, the value changes according to the corresponding table below.

• D Flip-Flop: When the clock rises from 0 to 1, the value remembered by the flip-flop becomes the value of the D input (Data) at that instant.

• J-K Flip-Flop: When the clock rises from 0 to 1, the value remembered by the flip-flop toggles if the J and K inputs are both 1 and the value remains the same if both are 0; if they are different, then the value becomes 1 if the J (Jump) input is 1 and 0 if the K (Kill) input is 1.

Pins

West edge, marked by triangle (input, bit width 1)

Clock input: At the instant that this input value switches from 0 to 1 (the rising edge), the value will be updated according to the other inputs on the west edge. As long as this remains 0 or 1, the other inputs on the west edge have no effect.

West edge, other labeled pin(s) (input(s), bit width 1)

These inputs control how the flip-flop's value changes during the rising edge of the clock. Their exact behavior depends on the flip-flop; the above tables summarize their behavior.

East edge, labeled Q, north end (output, bit width 1)

Outputs the value currently stored by the flip-flop.

East edge, south end (output, bit width 1)

Outputs the complement of the value currently stored by the flip-flop.

Attribute

Keines.

Verhalten des Schaltwerkzeugs

Keines.

Verhalten des Textwerkzeugs

Keines.

Zurück zur Bibliotheksreferenz